Please note: This project is no longer active. The website is kept online for historic purposes only.
If you´re looking for a Linux driver for your Atheros WLAN device, you should continue here .
Version 2 (modified by, 13 years ago)


In some places you will find the name of the chipset instead of the name of the chip

Atheros reference design

Chipset:AR5210 (802.11a only)
Antenna Connector:(unknown type)
Device Information:168c:0007 Subsystem: Unknown device 168c:1011

Atheros AR5001X+

Chipset:AR5001X+ = (AR5211 + AR5111 + AR2111)
Chip:AR5211 (802.11a +???)
Supports:IEEE 802.11a, 802.11b, 802.11g

Atheros AR5002X

Chipset:AR5002X = (AR5212 + AR5112)
Chip:AR5212 (802.11a +???)
Supports:IEEE 802.11a, 802.11b, 802.11g

Atheros AR5002G

Chipset:AR5002G = (AR5212 + AR2112)
Chip:AR5212 (802.11???)
Supports:IEEE 802.11b, 802.11g

Atheros AR5004X

Chipset:AR5004X = (AR5213 + AR5112)
Chip:AR5213 (802.11a +???)
Supports:IEEE 802.11a, 802.11b, 802.11g

Atheros AR5004G

Chipset:AR5004G = (AR5213 + AR2112)
Chip:AR5213 (802.11???)
Supports:IEEE 802.11b, 802.11g

Atheros AR 5005G

Chipset:AR5005G = (AR2413)
Chip:AR2413 (802.11b+g)
Supports:IEEE 802.11b, 802.11g
Working: not working with version 0.9.2, dmesg reports: "unable to attach hardware: 'Hardware revision not supported' (HAL status 13)"
Notes: Several tickets indicate this; no response was ever given. However, some users have reported success, but could not confirm this.
Notes: Works perfectly on Slackware 11 (kernel and madwifi 0.9.2. Just modprobe ath_pci after compiling/installing. (this on an Acer 3102 wlmi)
Notes: I can confirm that this chipset works great with the madwifi-ng drivers on Debian Testing. Also monitor mode.
Notes: chipset is AR1423, as you can see through URL
Notes: This chipset works on the Acer Aspire 5040 if you install the acer_acpi driver
Notes: Works on the Acer Aspire 3053 if you reload the modules (see and then run depmod -a (as root)
Notes: Works on the Acer Aspire 5051 using madwifi source pulled 2006-12-18 (OpenSuSE 10.2/x86_64)
Notes: Cheap Ativa card works ok in gentoo. /etc/init.d/net.athx start does not ifconfig athx up the device, so preferred wireless won't work

Atheros AR5005VL

Chipset:AR5005VL = (AR5513)
Chip:AR5513 (802.11a+b+g)
Supports:IEEE 802.11a, IEEE 802.11b, 802.11g
Notes:As of 2006-06-10 the HAL does not support this chipset.

Atheros AR5006EG

Chipset:AR5006EG = (AR2423)
Chip:AR2423 (802.11a+b+g)
Supports:IEEE 802.11a, IEEE 802.11b, 802.11g
Device Information:TBD
Notes:works with madwifi-r2153-20070224
Notes:Works on Toshiba Satellite A135
Notes:Had to change order of module insertion. Works when order is:modprobe wlan_scan_sta,modprobe wlan_wep,modprobe ath_pci

Atheros AR5006XS

Chipset:AR5006XS = (AR5414)
Chip:AR5414 (802.11a+b+g)
Supports:IEEE 802.11a, IEEE 802.11b, 802.11g
Device Information:168c:001b
Notes:works with madwifi-r1352-20051208

Atheros AR5007EG

Chipset:AR2425 / AR5007EG
Supports:802.11b 802.11g
Interface:PCI-Express x1
Device Information:168c:001c
Notes:not supported by HAL as of 2007.03.12

Atheros AR5BXB6

Supports: IEEE 802.11b, 802.11g
Notes: Works great with Madwifi included with Ubuntu Feisty. A 108Mbps mini-pci Express card.

Atheros AR5BXB61

Supports: IEEE 802.11b, 802.11g
Notes:Works with madwifi 0.9.3 under Ubuntu Edgy on Samsung R20 laptop.
Notes:Didn't try madwifi driver provided by Ubuntu (restricted-modules).
Notes:To get DHCP working might be necessary to bring down other network interfaces (e.g. the LAN interface with following command for Ubuntu: "sudo ifdown eth0").